Zeck Audio STAC Force180 Guia de Instalação descarregar pdf (Página 36)

Rev. 1.00 12-02-13 36/41

Set layer 2 COS for PPP and PPPoE packets

First appeared in build series: 2012-07-18

Layer 2 COS can be configured for PPP and PPPoE control frames. This configuration is only applied

when PPP/PPPoE packets are encapsulated in IEEE 802.1Q tagged frames. This new feature allows

traffic prioritization of PPP/PPPoE packets and adds a way to provide best effort QoS or CoS at layer 2.

Select the PPPoE session to configure this feature

Mode: session <name>

Command

Purpose

Step 1

[node](session)# ctrl-frame-layer2-cos [ 0 | 1 |

.. | 7 ]

Set the layer2 COS for PPP/PPPoE

control frames (default: 7)

Note: use ctrl-frame-layer2-cos without

parameter to revert to the default.

Administrator exec mode login

First appeared in build series: 2012-07-18

Administrator users do have the privilege to enter the “administrator exec” mode by issuing the command

“enable” right after login. With the following configuration command it is possible to allow all administrator

user on a SmartNode to skip that step. By enabling the configuration command below, an administrator

will directly be in the “administrator exec” mode after he logged in.

Mode: configure

Command

Purpose

Step 1

[node](cfg)#[no] cli login administrator-exec-

mode

Enable direct entering of “administrator

exec” mode after login (default:

disabled)

Set G.S power backoff

First appeared in build series: 2012-07-18

The power backoff on the G.S card can be reduced. By default this power backoff is set to 0dB but it

might be needed to reduce it with long distance line.

To configure select the correct dsl port.

Mode: port dsl <slot> <port>

1 2 ... 31 32 33 34 35 36 37 38 39 40 41

Sem comentários

Zeck Audio STAC Force180 Guia de Instalação Página 36