Zeck Audio STAC Force180 Guia de Instalação descarregar pdf (Página 3)

Rev. 1.00 12-02-13 3/41

History of Solved CTS Cases

The following list refers to open cases in the Change Tracking System 'CTS'.

This Build Series 2013-01-15

11214 Ethernet speed capability for manual settings

Defining the speed and duplex on Ethernet ports resulted in using auto negotiation with

restricted capabilities. It is now possible to define the speed and duplex settings manually

without having auto negotiation enabled. See full details in the New configuration commands

section.

11944 Action script trigger for SIP registration

It is now possible to execute user defined CLI commands in case of a SIP gateway

registered/unregistered event. Refer to the section New Configuration Commands for a detailed

description.

11984 G.SHDSL interface software upgrade failed

The software upgrade failures of the G.S interface have been fixed. The problem was that the

DSL supervisor tried to access the card during upgrade in order to check the interface status

but did not get a proper response. Consequently the supervisor considered the card is not

responding and immediately triggered a hard reset. Now the supervisor is temporarily turned off

while an upgrade is running.

12079 RTP payload type conflict

SmartWare internals specified that the RTP payload type 96 was reserved for DTMF relay

according to RFC2833. This lead to conflicts when another codec was configured to use

payload type 96, even when DTMF relay is disabled. The internal RTP payload type for DTMF

relay is now changed to 127 to reduce the probability of conflicting configurations.

12115 G.SHDSL mode auto detection fixed

Mode auto detection for the G.SHDSL interface only worked for the first connection attempt

when connected to Huawei DSLAM. This has been corrected such that any mode switches on

the DSLAM will be correctly detected on the SmartNode‟s interface.

12120 Support for short delay re-INVITE in SBC scenario

The SIP state machine has been enhanced to support an SDP renegotiation happening very

quickly in an SBC scenario. When receiving a new offer (re-INVITE) before the call status

switches to the connected state on the calling side, the SIP state machine got into an error

state.

12125 SN4991 Models with ADSL interface supported

1 2 3 4 5 6 7 8 ... 40 41

Sem comentários

Zeck Audio STAC Force180 Guia de Instalação Página 3