Zeck Audio STAC Force180 Guia de Instalação descarregar pdf (Página 33)

Rev. 1.00 12-02-13 33/41

First appeared in build series: 2012-07-18

With this command the SmartNode can be configured to automatically detect the G.SHDSL service-

mode. It is able to detect whether it is connected to a 2-wire or a 4-wire line. The feature does not detect

the interleave nor the enhanced mode. The preferred mode in case a 4-wire line is detected must be

configured by the user. Therefore the original service-mode command behaves as a preferred service

mode if this feature is enabled. It allows defining the exact 4-wire mode to be selected in case a 4-wire

line is detected. Please note that this command is only available if G14 release or later is installed to the

G.S interface.

Mode: port dsl

Command

Purpose

Step 1

[node](prt-dsl)[0/0]#[no] autodetect-service-

mode

Enable/disable the G.S service-mode

auto-detection feature (default: disabled)

Setting annex type

First appeared in build series: 2012-07-18

Mode: port dsl

Command

Purpose

Step 1

[node](prt-dsl)[0/0]#annex { a | b | m }

Sets the annex type for dsl port

operation (default: a)

Setting up permanent virtual circuits (PVC) for PPPoE

First appeared in build series: 2012-07-18

Mode: port dsl

Command

Purpose

Step 1

[node](prt-dsl)[0/0]#[no] pvc-ethernet <vpi>

<vci>

Creates a PVC and enters configuration

mode for this PVC. The "no"-variant

deletes the PVC configuration.

Mode: pvc ethernet

Step 2

[node](pvc)[vpi/vci]# encapsulation { llc | vc }

Sets the encapsulation to be used.

Optionally select either LLC

encapsulation or VC multiplexing for this

PVC (default: llc)

Using PVC channel with PPPoE

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40 41

Comentários a estes Manuais

Sem comentários

Zeck Audio STAC Force180 Guia de Instalação Página 33

Comentários a estes Manuais