Zeck Audio STAC Force180 Guia de Instalação Página 1

Patton Electronics Company, Inc. 7622 Rickenbacker Drive Gaithersburg, MD 20879 USA Tel. +1 (301) 975-1000 Fax +1 (301) 869-9293 [email protected] h

Rev. 1.00 12-02-13 10/41 H.323 offers the capability to suspend a call by sending an empty Terminal Capability Set (TCS) and to resume it again b

Rev. 1.00 12-02-13 11/41 The SmartNode analog devices now support DTMF caller ID transmission on FXS ports. DTMF CID protocol can be fully config

Rev. 1.00 12-02-13 12/41 does not send any final answer to the INVITE request. This is now corrected and SmartWare sends in addition to the “200

Rev. 1.00 12-02-13 13/41 11936 Broken T.38 transmission The problem manifests itself through continuous „voice‟ detection at the beginning of t

Rev. 1.00 12-02-13 14/41 The software upgrade procedure for the G.S interface card has been improved and now gives a complete error description i

Rev. 1.00 12-02-13 15/41 - Brazil (Anatel 220-250-713) Refer to the New configuration commands section to find out how to configure this feature

Rev. 1.00 12-02-13 16/41 In this specific scenario a Fax transmission is detected based on the CED tone. The configured T.38 fax relay protocol i

Rev. 1.00 12-02-13 17/41 11842 SN5200 hardware-version 6.X support For the SN5200 device, hardware-version 6.X support has been added. 11844 CE

Rev. 1.00 12-02-13 18/41 11855 Ethernet lockout on SN4660/70 On the SN4660 device series it could happen that the ethernet protocol enters a loc

Rev. 1.00 12-02-13 19/41 11684 Timestamp enhancement for milliseconds 11685 Enhanced spoofed contact to accept hostname 11697 Fax T.38 not wor

Rev. 1.00 12-02-13 2/41 About this Release R6.T is a SmartWare Technology Release. Please see the White Paper about SmartWare software releases h

Rev. 1.00 12-02-13 20/41 Caveat - Known Limitations The following list refers to open cases in the Change Tracking System 'CTS' CTS2236

Rev. 1.00 12-02-13 21/41 However, care should be taken in analog line extension applications, to make sure that the flash-hook event is allowed t

Rev. 1.00 12-02-13 22/41 CTS11786 On older SmartNodes the two debug monitors debug media-gateway rtp and debug call-control print out incorrect R

Rev. 1.00 12-02-13 23/41 General Notes Factory Configuration and Default Startup Configuration The SmartNodes as delivered from the factory conta

Rev. 1.00 12-02-13 24/41 New Configuration Commands The commands documented in the Release Notes only cover new additions which are not yet inclu

Rev. 1.00 12-02-13 25/41 Command Purpose Step 1 [node](act)[RULE]# condition ip <routername:interfacename> { LINKUP | LINKDOWN } Defines t

Rev. 1.00 12-02-13 26/41 Registration nat-traversal mode: nortel (no change) This is the nat-traversal method to use together with certain Nort

Rev. 1.00 12-02-13 27/41 match, a new REGISTER request with corrected values is sent out. This can happen over the same flow as the previous one

Rev. 1.00 12-02-13 28/41 Command Purpose Step 1 [node](callout)# [no] nat-traversal flows Configured if INVITE requests are sent out through flo

Rev. 1.00 12-02-13 29/41 The conversion from AOC to tax pulses is rounded up to provide a higher charge to the user in case of doubts in a way th

Rev. 1.00 12-02-13 3/41 History of Solved CTS Cases The following list refers to open cases in the Change Tracking System 'CTS'. This B

Rev. 1.00 12-02-13 30/41 Enable/disable early-proceeding on SIP interface First appeared in build series: 2012-12-03 In SBC scenarios, it is pos

Rev. 1.00 12-02-13 31/41  1000Base-SX => configure for Gigabit Ethernet Fiber/Copper module  100Base-FX => configure for Fast Ethern

Rev. 1.00 12-02-13 32/41 Screening-indicator (for advanced use) Besides the basic setting (enabled/disabled) a third option „screening-indicator‟

Rev. 1.00 12-02-13 33/41 First appeared in build series: 2012-07-18 With this command the SmartNode can be configured to automatically detect the

Rev. 1.00 12-02-13 34/41 First appeared in build series: 2012-07-18 Mode: pvc ppp Command Purpose Step 1 [node](pvc)[vpi/vci]# pppoe Enters PPPo

Rev. 1.00 12-02-13 35/41 Using PVC channel with IPoA First appeared in build series: 2012-07-18 Mode: pvc ip Command Purpose Step 1 [node](pvc)[

Rev. 1.00 12-02-13 36/41 Set layer 2 COS for PPP and PPPoE packets First appeared in build series: 2012-07-18 Layer 2 COS can be configured for P

Rev. 1.00 12-02-13 37/41 Command Purpose Step 1 [node](prt-dsl)# [ no ] power-backoff { 0dB | -1dB | -2dB | .. | -12dB } Reduce the power backof

Rev. 1.00 12-02-13 38/41 Documentation CD-ROM The CD-ROM that is delivered with SmartNodes includes user documentation and tools for SmartWare R6

Rev. 1.00 12-02-13 39/41 How to Upgrade 1. You have the choice to upgrade to R6.T with or without the GUI functionality. To upgrade to R6.T witho

Rev. 1.00 12-02-13 4/41 Software support for the ADSL interface is introduced for SN4991 Models. The configuration of these is equal to the exist

Rev. 1.00 12-02-13 40/41 Notes about Upgrading from Earlier Releases Note that SmartWare Release R6.T introduces some changes in the configuratio

Rev. 1.00 12-02-13 41/41 How to submit Trouble Reports Patton makes every effort to ensure that the products achieve a supreme level of quality.

Rev. 1.00 12-02-13 5/41 11958 SIP AOC XML support It is now possible to send and receive SIP Advice Of Charge information in XML format. Refer t

Rev. 1.00 12-02-13 6/41 The SFP (Fiber) interface present on some SmartNodes is supported with this build. It is represented with the new port et

Rev. 1.00 12-02-13 7/41 11854 Support for 4300/JO and 4400/JO products Added support for the following products:  SN4312/JO  SN4316/JO  SN

Rev. 1.00 12-02-13 8/41 12045 Concurrent Dynamic IP Configuration (DIC) removes default gateway DIC protocols addressed in this ticket: DHCP, PP

Rev. 1.00 12-02-13 9/41 On 6.T releases the Message-Waiting-Indication on FXS ports was not working anymore. This has been fixed. 11860 SIP re-r